McAfee M-2750 - Network Security Platform Guia do Utilizador

This Quick Start Guide explains how to quickly set up and activate your McAfee® NetworkSecurity Platform M-2750 Sensor in in-line mode. Cabling the Se

9 You're up and running!Your Sensor is actively monitoring connected segments and communicating with the Manager foradministration and management

11

Copyright © 2013 McAfee, Inc. Do not copy without permission.McAfee and the McAfee logo are trademarks or registered trademarks of McAfee, Inc. or its

Sensor setup overviewThis section explains how to position and cable the various ports of your Sensor. This section also brieflyexplains how to instal

dInstall the redundant power supply (optional). eInstall modules in the Sensor's Monitoring ports. 2 Cabling the Management and Console portsEn

The required settings for HyperTerminalare:• Baud rate: 38400 • Stop Bits: 1• Number of Bits: 8 • Control Flow: None• Parity: NoneePlug the female end

Following steps briefly explain the Manager installation:aPrepare the system according to the requirements outlined in McAfee Network Security Platfor

cAn add-on license is required to enable NAC on M-series Sensors. To import and assign anadd-on license, go to Device List | Add-On Licenses page. For

At any time during configuration, you can type a question mark (?) to get help on the Sensorcommand-line interface (CLI) commands. For a list of all c

iPing the Manager from the Sensor to determine if your configuration settings to this point havesuccessfully established the Sensor on the network. At

bReturn to the Manager. In the Manager Home page, view the Manager status in the System Healthsection.Manager status should be up and Sensor status sh